stainless steel bump guard popping screws

Start
Prev
1
Next
End

a Guest
Topic Author
Visitor

14 years 6 months ago #1110 by a Guest

stainless steel bump guard popping screws was created by a Guest

I have over the years had to replace several screws holding the stainless steel strip on the teak toe rail.
I have seen other ip's with this problem where the railing doesnt actiually match the curve of the teak, so the wcrews pop. The place is the same, by the starboard entry gate.
Anyone else experience this?

Please Log in or Create an account to join the conversation.

hayden
Offline
Moderator

14 years 5 months ago #1113 by hayden

Replied by hayden on topic Re: stainless steel bump guard popping screws

This also happens to me. I take a sliver of wood, and some epoxy and jam the wood into the old screw hole. Then when it dries, I thread the screw back into this filled hole.
Hayden

Hayden Cochran
IP35-165 Island Spirit
IslandSpirit35.blogspot.com
Rock Hall, MD

Please Log in or Create an account to join the conversation.

a Guest
Topic Author
Visitor

14 years 5 months ago #1117 by a Guest

Replied by a Guest on topic Re: stainless steel bump guard popping screws

Someone who owns an ip35 mentioned that the end of a zip tie works really good also. He just places the appropriate sized end of a zip tie and then installs the screw.

Please Log in or Create an account to join the conversation.

Start
Prev
1
Next
End

Time to create page: 0.101 seconds

Disclaimer

Sincerely,

The International IPYOA administration team.