Accessing factory prewiring

Start
Prev
1
Next
End

njoynthewater
Topic Author
Offline
New Member

7 years 10 months ago #6210 by njoynthewater

Accessing factory prewiring was created by njoynthewater

Hi everyone, new owner of an IP 370. I am looking at adding ventilation fans throughout. The 12 volt electrical diagrams appear to show that the boat is predicted throughout. If that is correct does anyone know how to access them from behind the cabin panels.

Please Log in or Create an account to join the conversation.

LJD610
Offline
New Member

7 years 10 months ago #6212 by LJD610

Replied by LJD610 on topic Accessing factory prewiring

Not a specific answer but on our 420 fans were added adjacent to reading lights and wired into them for power.

Lamar

The following user(s) said Thank You: njoynthewater

Please Log in or Create an account to join the conversation.

hayden
Offline
Moderator

7 years 10 months ago #6213 by hayden

Replied by hayden on topic Accessing factory prewiring

Darryl
Most IPs have coils of BLUE wire sip tied up into the cabinets when you would want a fan. On our IP 35 this was the qtr berth lockers and the v-berth sliding lockers and the galley shelf and the nav desk area. Look for zip tied coils of blue wire. These are the pre-wired drops.
Hayden

Hayden Cochran
IP35-165 Island Spirit
IslandSpirit35.blogspot.com
Rock Hall, MD

Please Log in or Create an account to join the conversation.

njoynthewater
Topic Author
Offline
New Member

7 years 10 months ago #6214 by njoynthewater

Replied by njoynthewater on topic Accessing factory prewiring

Thanks for the reply. They must have made a change as I haven't been able to find any coiled wire tie wrapped anywhere in our boat.

Please Log in or Create an account to join the conversation.

Start
Prev
1
Next
End

Moderators: acajun, shawnee

Time to create page: 0.105 seconds

Disclaimer

Sincerely,

The International IPYOA administration team.