Temperature gauge

Visibility Public

by Glen Roger 21 April 2011 Engines 9 photos 4259 views

Captain Jim Stengel described this add-on. I got the parts with help from Bobby Ward. Simple job! Even a klutz can do it.

Bought a tee so I could insert the temperature probe. Didn't need the nipple.

Old plumbing from the thermostat to the lines leading back to the hot water heater. Galvanized?

Took off the old elbow, put in the tee. Hope it is OK to mix galvanized with brass.

A look from the other side.

Wire leading back to the panel. Check out the cool wire "coiling." Very professional.

The buzzer comes out easily after you screw off the backing ring.

The new temp gauge goes in the same hole - no cutting or drilling.

Set to put the panel back in.

Wow! New temperature gauge on our Yanmar 4JH2E.

Disclaimer

Sincerely,

The International IPYOA administration team.